RTH1800DI Humminbird Mega Down Scan ONLY TO MotorGuide Xi5 or Similar Round Nose Cone MotorsThe RyTek Marine RTH1800DI+SI Trolling motor mount is for the Humminbird XTM 9 HW and 14 HW Down Scan ONLY Transducers and are designed for the Motorguide Xi5 Trolling Motor or similar with rounded nose cone motors! Our dedicated MotorGuide Xi5 trolling motor mounts are purpose built for the Xi5 80 & 105lb thrust motor and sit tight up against all parts of the motor housing (no gaps to catch weeds!!!) The RTH1800DI is a fully guarded mount constructed

These two connecting rods fit on the "knuckle" area where the trolling motor shaft meets the motor housing right on top of the motor body

The mount is built entirely out of 1/8" 304 Stainless Steel

Heavy Duty transom screws are available thru our transducer accessories page

The Narrow Caddie has 6 pockets (one single row of deep 5

Please confirm the dimensions of your trolling motor to the dimensions picture below to make sure your trolling motor will work with the mount

XM 14 20 MSI T

The bracket can be installed on the boat without having to pull the transducer cable from the boat (difficult and time consuming)

These are not stocked but are made in runs of 6-10 pairs

Find it here  https://rytekmarine

preventing rust and mold from building up like other tool holders on the market

Our RTL3100 Lowrance LiveSight Dual Purpose Trolling Motor Top-Mount is a dedicated LiveSight transducer mount for the following four trolling motors:

Watch this YouTube video for instructions on how to use the Drilling Jig and drill your pole mount shaft