Test code for machine tools - Circular tests for numerically controlled machine tools1 Scope This part of ISO 230 specifies methods of testing and evaluating the bi directional circular deviation, the mean bi directional radial deviation, the circular deviation and the radial deviation of circular paths that are produced by the simultaneous movements of two linear axes. Relevant measuring instruments are described in ISO 230 1: 1996, 6. 63. The objective of this part of ISO 230 is to provide a method for the measurement of the

BS EN 16246 taken together with EN ISO 4254-1

BS EN 12309-5 is the fifth part of the series that specifies the requirements for gas-fired sorption appliances for heating and/or cooling with a net heat input not exceeding 70 kW

Why should you use BS EN 4644-022 -Plug with mounting holes for electrical connectors

NOTE Quantification of the level of exposure allows selection of the correct type of protection for the operators and

rectangular or circular passages

ensuring barrier performance and noise reduction in railway applications

BS EN 61672-3 describes procedures for periodic testing of time-weighting

Who is BS EN 61966-2-2 - Colour measurement and management for

expressed as diphosphorus pentoxide between 0

Who is BS ISO 20000-3 for

ISO 11124-3 specifies requirements for high-carbon cast-steel shot and grit as supplied for blast-cleaning processes

that is needed by stakeholders as different stakeholders will have different needs