TE-DFN-A0448-00 | Dwyer | Termperture Sensors & TransmittersThe Series TE Duct and Immersion Temperature Sensor can be used to monitor air or water temperature throughout a building management system or an air handler unit. Flanged duct sensors monitor the supply or return air and provide a thermistor or RTD output to the digital controller. Immersion sensors which are supplied with compression fittings are typically used to monitor the hot or chilled water lines throughout a building. Thermowells are

LMCB24-SR Damper Actuator

6 body make the series ADPS ideal for use with air and other noncombustible gases

Flow sensor 1 1/4"

Average Temperature Sensor passive

and offers several output options including selectable BACnet MS/TP or Modbus® RTU communications protocol over 2-wire RS-485 in addition to the standard analog

In addition to the standard analog signal and feedback wiring

NFBUP-S Damper Actuator

Duct Sensor CO2 / Humidity / Temperature active

1/2" pressure independente control valve with BTU Meter

Ni1000 (JCI)

JACE 8000 100 Device Core Software Only & 5000 Points

Option cards required for communication to remote devices are not included