Rotary Rebar Cutters, 1-3/4", SDS-Plus Shank, CarbideStraight Shanks No need to relocate the hole to avoid the rebar Teeth can be sharpened or replaced as necessary Shank has three flats to eliminate slippage in 3 jaw chuck Design to drill dry, no water or coolant required Carbide teeth design for rotary use only To be used with rotary function only, percusion will break the carbide teeth Available in 1 2" straight shank or SDS shank 1. Stop hammer bit when rebar is encountered 2. Using same size rebar

Ground starting taper on cutting end for easy entry

Separate feed control of both feed rate and feed pressure

blending and sanding a broad range of substrates including primed or painted surfaces

000 RPM for high output power

if run over it will return to its original shape

For use on portable or stationary angle grinder or bench grinder

unitized construction can operate in both clockwise and counter clockwise directions

6" (Tip Angle 18o

Aluminum base construction delivers maximum durability

These indicators have a shockless

which is lighter yet 3 times stronger than grey iron cast vises

01 Straight