MINI HEART LACE SQUARE DIE SET - Gina Marie DesignsLargest layer cuts 4x4 Tips and tricks for die cutting When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a better cut using this

I find it applies the most pressure from the roller to the blade of the die and not the back of it

Largest layer measures 4x5

That means to run them in by a corner first and not flush into the machine

It frames beautifully on an A2 card

The longest is approx 3 inches and they are just over

Believe it or not most cutting machines say to cut with the die facing up

THEY SHOULD BE BRAND NEW BUT THERE COULD BE A FEW IN WHAT WE ARE SELLING THAT MAY HAVE A STAMP OR TWO IN THE SET USED

High Quality photopolymer

It's very important to GMD to test all products prior to selling them and unfortunately while manufacturing in the usa that was not an option given to us

5 largest layer

Die measures 4x4

Largest layer cuts approx 4x4