Hot Racing - Heavy Duty Spiral Cut Bevel Gear Set, 36/14 Tooth, for Axial AX10This is the Hop Up Spiral Diff Bevel Gear set for Axial AX10, Wraith Ridge Crest, and EXO Series. This gear is attached to the diff case and mounts in the front or rear gearbox. FEATURES: Precision machined gears High carbon steel construction YOU WILL RECEIVE: One 36 tooth diff bevel ring gear gear One 14T bevel gear REQUIREMENTS: Installation following the kit manual and one M3x2. 5x11mm screw pin Do not use the stock 3x3 set screw

Hard anodizing or Hardcoat is an electrochemically produced grey layer of hard aluminum oxide on the surface of aluminum components

Zero Shock Silver 104mm (4)

Motor Type: 3 Pole Bearing Type: None Speed (4

5mm hex key Four 2x10mm drivr pin

XD Aeration Shock 75mm

One aluminum engine mount 10 x 19 x 5 mm bearing

1/10 Scale Aluminum Silver Tow Shackle D-Rings (4)

Lower shock ends includes red anodized aluminum balls

1/16 Mustang

5x11mm screw pin Do not use the stock 3x3 set screw

Blue Aluminum construction

Clamp Type Aluminum 12mm Wheel Hub (4) (5mm Thick)