FEATHERED LACE RECTANGLE DIES - Gina Marie DesignsTips and tricks for die cutting When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a better cut using this trick! Plate dies and

This die cuts best FACE UP and at an ANGLE

Measures approx 4

This dies largest layer drops pierce dots at approx 4

Bear stamp set is a current set out by momma elephant as of 5-20-16

The inner lattice panel is VERY tiny and petite

PLEASE NOTE

Please Note -

Largest layer approx 4x4

Beautiful full panel die

5 inch wide

AS SHOWN ON THE EXAMPLE THIS DIE ONLY PIERCES THE DOTS IN THE SHAPE OF THE DIE

3 piece die set