Dexter Drive Belt – 9040-079-003This drive belt is used in Dexter commercial laundry equipment to transmit power from the motor to the driven components, supporting proper drum rotation and system load balance. Correct belt selection is critical for maintaining designed speed ratios and minimizing stress on motors and bearings. Specified by Dexter under part number 9040 079 003, this belt is intended for direct replacement in compatible Dexter washer or dryer drive assemblies where

Cotton Ironer Belt — 2" x 120"

supporting reliable motor

Maintenance Tip: Always inspect shaft condition and mounting surfaces during bearing replacement to prevent premature failure of the new bearing

technicians can perform rapid belt replacements and fine-tune belt length directly on the machine

verify proper alignment against the drum face and inspect mating surfaces for debris before installation to ensure uniform sealing pressure

Technicians value the belt’s predictable trimming behavior and stable response under tension

Normal State Normally closed (N/C)

or buildup on the roll surface

Whirlpool Water Jet Pressure Switch (WFR136987)

heat fatigue

Made from the original factory specifications and manufactured in the USA

along with its right-angle design