Universal Bar Clamp Kit, C-3For clamping a Universal bucket elevator belt together. Model Size C 3

The clipper part numbers are F030-15503 and F030-16510

This is an upgrade kit for the Clipper Number 51 brush drive system

The is the standard-length auger tube for the Eliminator 224 seed cleaner

Some specifics:

Eliminator 224 & Clipper M-2B Brush drive shaft bearing with flange

This is the large gear on the clipper number 51 brush-drive system

It is used on the fan shaft for the Clipper M-2B seed cleaner and it is driven by the 3 step pulley on the eccentric shaft

These sprockets are also used on Clipper M-2Bs that have the updated cable kit installed on the older brush drive system

The chain which runs the brush system with attachment link

If it is used on the clipper hoppers it is not necessary to grease the bearings because the original bearings on clipper hopper were not greaseable

This clamps onto the cable and it sits in the crows foot of a clipper H frame brush carrier

Not all M-2b seed cleaners have a roll feed hopper