Shrink chuck 4,5° HSK 100 - 18 - 120Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Chrome molybdenum steel ( or Chrome vanadium steel ) square drive

Only nominal size d can be clamped (applicable up to 120 bar)

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance2

Delivery with test certificate All holders are made of forged steel

without the illustrated cutting tools

The caliper will be ready for measurements as soon as it is switched on with the LCD screen displaying the actual slider position

Carbide tipped measuring faces

For face machining

For mounting straight-shank tools in collet chucks DIN 6391

- Longer-lived than standard collets

Eingebauter Niederzug

With retaining screw