Metallic and other inorganic coatings. Electrodeposited coatings of tin-cobalt alloy1 Scope This International Standard specifies electrodeposited coatings of tin cobalt alloy of approximate composition 75 % (mass fraction) to 80 % (mass fraction) tin, remainder cobalt, as a substitute for decorative chromium coatings of 0,1 m to 0,3 m thickness. Hardness and wear resistance properties of the coatings obtained are not equivalent to those of chromium coatings, but similar to those of tin nickel alloy coatings. Tin cobalt alloy

data archiving

BS EN 61753-092-6 cover the requirements and test methods for non-connectorized single-mode circulators for category O

The presence of metalloids at or near the eutectic concentration

and procedure in absence of identification signal

the method is applicable

Combination with other systems

They shall be used in the temperature range − 55 °C to 163 °C

Association of British Certification Bodies

The insulation and other components are suitable to permit operation of the cables at a maximum sustained conductor temperature of 90 °C and for a maximum short-circuit conductor temperature of 250 °C

interlaminar shear strength is one of the mechanical properties of advanced technical ceramics that demonstrate the ceramic's resilience to fatigue under shear stresses

transport and maintenance

DD CEN ISO/TS 17892-6:2004 Geotechnical investigation and testing