SLASH STITCHED SQUARE DIE SET - Gina Marie DesignsTips and tricks for die cutting When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a better cut using this trick! Plate dies and

Largest layer cuts approx 4

Largest layer measures 4x5

PLEASE NOTE this die is a smidge smaller than a 4

Each measures approx 3x3

High Quality photopolymer

approx 4x4

BOTH STAMP AND DIES ARE INCLUDED IN THIS

Die measures 4x4

The card in the photo are those actual measurements and the die is nested just inside

Largest layer measures 4

Largest layer cuts 4x5

Largest layer is approx 4x4