Ergonomic design of control centres - Introduction to the control room design series of standards1 Scope This document describes the different parts of the ISO 11064 series. The overall content of each of the parts is presented, the most likely users of that part and the relevance of each part to different stages in the control room design process.

These standards are invaluable to those who want to demonstrate compliance with the European Pressure Equipment Directive (the PED)

The primary application of this standard is to provide a common basis for the determination of the odourplume extent in the member states of the European Union

BS EN 4346 is part of the series of EN metallic material standards for aerospace applications

Hacksaw frames are designed to help the users to wield the hacksaw blade safely and apply pressure on the blade while cutting without harming themselves

The advantage of investment castings is the complexity of the shapes that can be cast

as are syntactic rules for the construction of codes in coding schemes

e) establish general principles for the calculation of primary energy factors and carbon dioxide emission coefficients

Redraft of clause 6 on instrumentation

EN 998‑2

Compliance with BS 5839-8 is very commonly required throughout the UK by building control bodies

BS EN 17082 applies to Type A2

and sharing information